Wiring, Rewiring & ADUs in Santa Cruz

Whether you're remodeling a kitchen, building a backyard ADU or finally updating the wiring in an older beach cottage, good planning makes all the difference. Electrician's Precision Pros handles new circuits, subpanels, ADU feeders and partial or whole-house rewiring across Santa Cruz, Capitola, Scotts Valley and Soquel. We work alongside your contractor, keep you in the loop, and make sure the new work and your existing system play nicely together.

Call +1 (831) 231-7014

Describe the problem and we'll tell you how quickly we can be there.

white circuit breakers — illustrative image for electrical services in Santa Cruz, CA

Projects we wire

Backyard ADUs and garage conversions
Kitchen and bathroom remodels
Heat pump, induction range and dryer circuits
Partial and whole-house rewiring
Grounded outlets in older homes
Outdoor circuits for decks, patios and gardens
Home offices and workshops

ADUs and garage conversions

An ADU needs its own electrical plan: a feeder from the main panel, a subpanel, kitchen and bathroom circuits, heating and cooling, and lighting. Before anything is built, we check whether your main service can support the new unit, and if it can't, we lay out options. We coordinate with your builder on rough-in and finish, and handle the permit and inspection.

Rewiring older Santa Cruz homes

Some Santa Cruz cottages and bungalows still have original wiring, two-prong outlets or circuits added over the decades without much planning. Coastal moisture can also take a toll on older connections. We inspect what's there and recommend whether a partial rewire, focused on kitchens, baths and the most-used circuits, or a full rewire makes more sense.

Keeping disruption low

We work room by room, keep openings small and in planned spots, and restore power to each area as it's finished. We clean up at the end of every day so you can get on with life while the work happens.

How a wiring job goes

Give us a call

Tell us what you'd like done or what's gone wrong. We'll ask a few friendly questions and figure out the next step together.

We take a look

We check the panel, the circuits and the space, and listen to what you're planning.

We talk it through

You get clear options in plain English, so you can choose what works for your home.

We do it properly

Work to current code with permits handled, tested before we leave, and the area left tidy.

Wiring questions

Can my existing panel support an ADU?

Sometimes. We run a load calculation to find out and explain the options if it can't.

Does rewiring mean opening every wall?

No. Most cable can be fished through existing walls with small access openings that are patched afterward.

Is a permit required?

Yes. New circuits, ADUs and rewiring all require permits and inspections. We handle them.

Can you work with my contractor?

Yes. We schedule rough-in and finish around your builder's timeline.